Kitchener Chicken Plucker Machine Poultry Bantams Defeather Feather
Plucking
Technical Details
1. Power Type
2. Including 2 wheels
3. Rotational speed: 280RPM
4. Including 92 fingers
5. Voltage: AC 120V
6. Wattage: 1.2HP
PLUCKING INSTRUCTIONS
1. Make sure all safety features are operational, including the
power switch and proximity
switch.
2. Check that all nuts and bolts are secure.
NOTE: All hardware (nuts, bolts, etc) should be checked for
tightness before each use.
Vibration of machine can cause them to loosen.
3. Keep electrical connections out of areas where water can pool.
4. Each time the chicken plucker is plugged in, you must press the
reset button on the leakage
protector. The machine will not start without this step.
5. Put the bird into scalding water should be approximately 65
degrees Centigrade (140-150
degrees Fahrenheit), plunging the bird in and out of the water for
about 1 minute. When the
bigger feather on wings can be pulled out easily by hand.
6. Recommend to mix the soap with scald water to make the oil on
birds’ feathers easily broken
down, which allows the hot water to penetrate to birds skin.
7. Press the start button on power switch and put the birds into
the plucker.
8. Drop the bird into plucker and let machine process until
feathers are removed. A properly
scalded bird will pluck in about 15-30 seconds.
9. Turn off the chicken plucker when finished.
NOTE: Do NOT retrieve bird unless unit has come to a complete stop.
BEFORE USE
1. Read and follow all instructions in the manual and on the unit
before starting.
2. Dress appropriately when operating the machine.
3. Removing all packing grease and oil from the surfaces.
4. Dry all parts before re-assemble.
5. Keep packing material for future storage of plucker.
6. Do not allow children to operate this machine.
AFTER USE
1. Turn off the machine, unplug before removing foreign matters.
2. Keep hands out of feather chute.
3. Disassemble all parts and wash thoroughly in soapy water.
4. You must remove all foreign material from all appliance parts.
5. Do not use bleach or chlorine based chemicals to clean.
Discoloration of plastic parts can
occur.
6. Wipe down all non stainless steel parts with a food grade spray.
Alternatively, wipe down
with a salad oil to keep from rusting.
7. Do not immerse motor housing in water. Damage to motor can
occur.
8. It is best to keep the unit stored indoors or covered, not
exposed to water and sunlight.
